Toro Reelmaster 6500–D Service Manual page 290

Remove Bedbar
1. Loosen bedknife adjusting knob to loosen bedknife to
reel contact.
2. Loosen locknut on bedknife adjuster assembly and
disengaging adjuster from bedbar. NOTE: On early pro-
duction cutting units there is no slot in bedbar for disen-
gaging bedknife adjuster from the bedbar; you must
completely unscrew adjuster assembly from pivot on
cutting unit frame.
3. Remove bedbar leveling screw and spring from L.H.
side of cutting unit.
4. Remove fasteners securing L.H. and R.H. bedbar
pivot hubs to frame.
5. Remove bedbar assembly.
6. Remove capscrew, washer and quad ring from R.H.
end of bedbar.
7. Remove R.H. and L.H. pivot hubs from bedbar.
8. Sharpen or replace bedknife as necessary (see Bed-
knife Replacement and Grinding).
Install Bedbar
1. Inspect bedbar end bushings and flange bushings for
wear and replace if necessary.
2. Install R.H. and L.H. pivot hubs onto bedbar.
3. Install quad ring, washer and capscrew to R.H. end of
bedbar.
4. Install bedbar onto cutting unit and secure pivot hubs
to frame with fasteners removed in step 4 above.
5. Install bedbar leveling capscrew and spring to L.H.
side of cutting unit.
6. Install bedknife adjusting knob assembly. Tighten
locknut to compress spring to dimension shown.
7. Adjust bedknife to reel (see Bedknife to Reel Adjust-
ment).
Cutting Units
Model 03853
Model 03854
Model 03855
2
1. Bedknife adjusting knob
2. Locknut
Page 7 – 14 Rev. B
1
Figure 19
1.25 (31.75 mm)
Spring 95–0772 (current design)
.670 (17 mm) Spring 93–2915
Figure 20
Reelmaster 6500–D/6700–D