Toro Reelmaster 6500–D Service Manual page 263

10. Use a puller to remove spindle (1) from housing (6).
Remove bearing cone (8).
11. Remove and discard all seals.
12. If bearings will be replaced, use a puller to remove
bearing cone (3) from spindle. Remove bearing cups (4
and 7) from housing (6).
Assembly of the Planetary Wheel Drive
NOTE: Use a new seal kit when assembling planetary
wheel drive.
1. Clean parts in solvent. Inspect parts for damage or
excessive wear and replace as necessary.
2. Install lip seal (2a) to spindle (1).
3. Press bearing cups (4 and 7) into housing (6).
4. Press bearing cone (3) onto spindle (1).
5. Install seal (2b) to housing (6). Assemble housing (6)
to spindle (1). Make sure seals are installed correctly
(Fig. 13a).
2b
23
Reelmaster 6500–D/6700–D
1 2a 3 4 6
7
8 9 10
Figure 13a
Page 6 – 9
6. Press bearing cone (8) onto spindle and secure with
thrust washer (9) and retaining ring (10).
7. Install seal (2c), then assemble ring gear (18) to hous-
ing (6) with capscrews (25).
8. Install secondary carrier assembly (11).
9. Install sun gear (21).
10. Install primary carrier assembly (12).
11. Assemble input shaft and sun gears (19, 20 and 23).
Install input shaft assembly.
12. Install thrust washer (17) and input spacer (16).
13. Install seal (2d), then install cover (15). Secure cov-
er with retaining ring (14).
14. Check operation of planetary wheel drive before
installing on the tractor.
25 5 2c 11 18
22 21 20
24
Axles, Planetaries and Brakes
Rev. A
12
16
15
19
17
13
14
2d