Toro Reelmaster 6500–D Service Manual page 270

Adjusting Pinion Shaft Cone Center
"Cone Center" is the distance from the mating face of
axle housing to end face of pinion. This distance can be
increased or decreased by installing removing shims.
Cone center specification
Shim stock for this adjustment is available in the follow-
ing thicknesses:
Thickness
Shim set
0.1 mm (0.004 in.)
0.2 mm (0.008 in.)
0.4 mm (0.016 in.)
Using gauge TOR4042 for cone center adjustment, de-
termine the required thickness of shim by proceeding as
follows:
1. Apply grease to o–rings. Install o–rings to sleeve,
then install sleeve assembly into adapter case.
2. Put gauge alternately on pinion shaft and select the
shim so that with the short gauge, a clearance will occur
between the gauge end and case face, but with the long
gauge, a similar clearance will occur between the gauge
and pinion end face.
3. Apply grease to o–ring and fit to mating face of sleeve.
Attach adapter case to axle housing (A) and secure by
tightening bolts to proper torque.
Adapter bolt torque
Axles, Planetaries and Brakes
43 ± 0.05mm
(1.69 ± 0.002 in.)
Part No.
77-4010
76-7410
76-7420
77-7430
2.5 ~ 3.0 kg–m
(18 ~ 22 ft-lb)
Page 6 – 16
Figure 24
Figure 25
Reelmaster 6500–D/6700–D