Safety And Instruction Decals - Toro Reelmaster 6500–D Service Manual

Table of Contents
SAFETY INSTRUCTIONS
Before Operating . . . . . . . . . . . . . . . . . . . . . . . . . . . .
While Operating . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Safety Instructions
The REELMASTER 6500-D and 6700–D was tested
and certified by TORO for compliance with the
B71.4-1990 specifications of the American National
Standards Institute when ballast is added. See Opera-
tor's Manual for ballast requirements. Although hazard
control and accident prevention partially are dependent
upon the design and configuration of the machine, these
factors are also dependent upon the awareness, con-
cern, and proper training of the personnel involved in the
operation, transport, maintenance, and storage of the
machine. Improper use or maintenance of the machine
can result in injury or death. To reduce the potential for
injury or death, comply with the following safety instruc-
tions.
Before Operating
1. Read and understand the contents of this manual be-
fore starting and operating the machine. Become famil-
iar with the controls and know how to stop the machine
and engine quickly. A free replacement manual is avail-
able by sending the complete model and serial number
to:
The Toro Company
8111 Lyndale Avenue South
Minneapolis, Minnesota 55420–1196.
Use the Model and Serial Number when referring to your
machine. If you have questions about this Service
Manual, please contact:
The Toro Company
Commercial Service Department
8111 Lyndale Avenue South
Minneapolis, Minnesota 55420.
2. Never allow children to operate the machine. Do not
allow adults to operate machine without proper instruc-
Reelmaster 6500–D/6700–D
. . . . . . . . . . . . . . . . . . . . . . 1
1
2
Page 1 – 1
Maintenance and Service

SAFETY AND INSTRUCTION DECALS

TO REDUCE THE POTENTIAL FOR INJURY
OR DEATH, COMPLY WITH THE FOLLOWING
SAFETY INSTRUCTIONS.
tion. Only trained operators who have read this manual
should operate this machine.
3. Never operate the machine when under the influence
of drugs or alcohol.
4. Keep all shields, safety devices and decals in place.
If a shield, safety device or decal is defective, illegible or
damaged, repair or replace it before operating the ma-
chine. Also tighten any loose nuts, bolts or screws to en-
sure machine is in safe operating condition.
5. Always wear substantial shoes. Do not operate ma-
chine while wearing sandals, tennis shoes, sneakers or
when barefoot. Do not wear loose fitting clothing that
could get caught in moving parts and possibly cause
personal injury. Wearing safety glasses, safety shoes,
long pants and a helmet is advisable and required by
some local ordinances and insurance regulations.
6. Assure interlock switches are adjusted correctly so
engine cannot be started unless traction pedal is in
NEUTRAL and cutting units are DISENGAGED.
Rev. B
Chapter 1
Safety
. . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . .
CAUTION
Safety
3
4