Toro Reelmaster 6500–D Service Manual page 337

3. Set the rear support bracket and side plate using the
approximate dimensions given by Table 1. The rear
support bracket is either in the top or bottom location,
and the side plate location can be in holes 1 thru 4, with 1
being the top hole (Fig. 15).
4. With the cutting unit rotated vertical, place gauge
bar across front and rear rollers. The first screw head
should fit snugly over edge of bedknife and the end of
second screw should contact bottom of bedknife
(Fig. 16). If there is a gap between the front roller and the
gauge bar, lower the front roller until it contacts the
gauge bar. Verify front roller (attitude) at each end of the
bedknife.
NOTE: At this time leave a small gap between the rear
roller and gauge bar.
Figure 15
1. Rear support bracket
2. Side plate holes
Reelmaster 6500–D/6700–D
1
1
2
2
ATTITUDE
"A"
2nd Screw
Page 8.1 – 11 Rev. C
Figure 16
1. 1st screw
2. 2nd screw
HOC SETTING
2.00"
(51 mm)
1st Screw
Figure 17
Cutting Units
Model 03857, S/N 80302 & Up
Model 03858, S/N 81419 & Up
Model 03859, S/N 81993 & Up