Procedure 33 Configuring The Leader Ip Address For A Second Or Subsequent Node - Avaya Nortel Communication Server 1000 Manual

302 Configuration of IP Telephony nodes using Element Manager
Transferring the configuration - second node
For a second (or subsequent) node, the process to transfer the node
configuration to the cards consists of the following steps:
1. Configure the Leader IP address. See
2. Transmit the node properties.
3. Configure the Follower card. See
Configuring the Leader network interface IP address
Follow the steps in
second or subsequent node" (page 302)
IP address of the Leader Voice Gateway Media Card.
Procedure 33
Configuring the Leader IP address for a second or subsequent node
Step
1
2
Copyright © 2003–2008, Nortel Networks
.
Server IP address information has been changed, such as the node IP
address or Signaling Server TLAN network interface IP address. The
Voice Gateway Media Cards require a reboot only if the card network
interface IP address information has changed.
Leader IP address for a second or subsequent node" (page
properties to Leader" (page
Follower cards" (page
Procedure 33 "Configuring the Leader IP address for a
Action
Access the IPL> or oam> CLI by connecting the COM port of a PC
to the RS-232 serial maintenance port on the faceplate of the Leader
Voice Gateway Media Card with an NTAG81CA PC Maintenance
cable.
If required, use an NTAG81BA Maintenance Extender cable between
the PC Maintenance cable and the PC.
Alternatively, connect the NTAG81BA Maintenance Extender cable
to the female DB-9 connector of the NTMF94EA ELAN, TLAN
RS-232 Ports cable for a more permanent connection to the Voice
Gateway Media Card serial maintenance port.
Never connect two terminals to the faceplate and I/O panel breakout
cable serial maintenance port connectors at the same time.
Use the following communication parameters for the TTY terminal
emulation on the PC:
• 9600 baud
•
8 bits
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
Procedure 33 "Configuring the
Procedure 34 "Transmitting node
304).
Procedure 35 "Configuring the
306).
to configure the network interface
ATTENTION
302).