Node Has Leader Configured - Avaya Nortel Communication Server 1000 Manual

550 Appendix F Moving Voice Gateway Media Cards between systems
•
Node has Leader configured
After you install the Voice Gateway Media Card, you should encounter one
of the three scenarios described in this section. Reconfigure the card by
following the directions for the applicable scenario.
If you encounter a scenario other than the three described in this section,
contact your Nortel representative.
Scenario 1
This scenario applies if the Voice Gateway Media Card:
•
•
•
If the startup message that appears is similar to that shown in
112 "Message output for the Voice Gateway Media Card when the BootP
response is received and accounts are" (page
"Reconfiguring a Voice Gateway Media Card running CS 1000 Release 4.5
or later (Follower on original " (page 552)
Media Card.
If you see a startup message different than what is shown in
"Message output for the Voice Gateway Media Card when the BootP
response is received and accounts are" (page 551)
connections, and make sure the configurations for the ELAN MAC address
are entered correctly in Element Manager. Then use
"Reconfiguring a Voice Gateway Media Card running CS 1000 Release 4.5
or later (Leader in original sy" (page 553)
Media Card.
If the BootP Server IP address is not the BootP Server IP address of the new
system, the response may be from the original BootP Server. Review the
message to make sure the IP address from which the card received the BootP
response is the Leader, or the current node master and BootP Server of the new
system. Verify the MAC address, and network connectivity.
Copyright © 2003–2008, Nortel Networks
.
A Leader is already configured in the destination node.
The node has no Leader configured.
A Leader is not configured in the destination node.
came from a system running CS 1000 Release 4.5 or later
was a Follower in that system
is moving to a CS 1000 Release 4.5 system or later
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
551), use
to reconfigure the Voice Gateway
to reconfigure the Voice Gateway
ATTENTION
Figure
Procedure 79
Figure 112
check your network
Procedure 80