Avaya Nortel Communication Server 1000 Manual page 240

240 Installation and initial configuration of an IP Telephony node
Installing and cabling the Media Card 32-port card
The Media Card 32-port line card is the successor of the ITG-P 24-port line
card. It increases the packet processing power of the ITG-P 24-port line
card, increases the channel density from 24 to 32 ports, and reduces the
slot usage from a dual slot to a single IPE slot. The Media Card 32-port card
requires only one slot in the IPE shelf.
CompactFlash installation
The Media Card package contains the following items:
•
•
•
The CompactFlash card must be installed on the Media Card before
installing the Media Card in the system. Follow the steps in
"Installing the CompactFlash card on the Media Card" (page 241)
the CompactFlash card.
If it is necessary to remove the CompactFlash card, follow the steps outlined
in Procedure 68 "Removing the CompactFlash" (page
Copyright © 2003–2008, Nortel Networks
.
The faceplate display window displays start-up self-test results (T:xx)
and status messages. A display "F:XX" indicates a failure of the
self-test. It is normal for the ITG-P 24-port line card to display "F:10"
during the start-up self-test. F:10 indicates that the self-test did not
find a Security Device. The ITG-P 24-port line card does not have
a security device.
Some failures indicate that the card must be replaced. See
118 "ITG-P 24-port line card faceplate maintenance display codes"
(page 438) for a list of the ITG-P 24-port line card display codes.
CAUTION
CATION WITH ESDS DEVICES
Wear an ElectroStatic Discharge strap when handling Media Card
line cards. As an additional safety measure, handle all cards
by the edges, and when possible, with the loosened packaging
material still around the component
Media Card
CompactFlash card
retaining pin
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
—End—
Table
Procedure 13
to install
491).