Avaya Nortel Communication Server 1000 Manual page 478

478 Voice Gateway Media Card maintenance
Command Description
Syntax:
pload "[patch-file name]"
where [patch-file name] is the file name or path of the patch file. If a file name alone
is provided, the patch must be in the /C:/u/patch directory; otherwise, the full or
relative path must be provided.
If the pload command is issued without a parameter, enter the patch file name and
other information when prompted.
Puts a patch that has been loaded into memory (using the pload command) into
pins
service. This command activates a patch.
If issued successfully, the pins command indicates that global procedures, functions,
or areas of memory are affected by the patch. When prompted, choose to proceed
or not to proceed.
Syntax:
pins "[handle]"
where [handle] is the number returned by the pload command
If the pins command is issued without a parameter, enter a handle when prompted.
Deactivates a patch (takes it out-of-service) by restoring the patched procedure
poos
to its original state.
Syntax:
poos "[handle]"
If the poos command is issued without a parameter, enter a handle when prompted.
Removes a patch from DRAM memory. The patch must be taken out-of-service
pout
(using the poos command) before it can be removed from the system.
Syntax:
pout "[handle]"
If the pout command is issued without a parameter, enter a handle when prompted.
Copyright © 2003–2008, Nortel Networks
.
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008