Avaya Nortel Communication Server 1000 Manual page 439

If a test fails on the Media Card, F:XX appears on the Hex display for three
seconds after T:13 message (Testing SEEPROM). For example, if the 8051
coprocessor test failed, F:05 is displayed on the Media Card faceplate. If
more that one test fails, the message indicates the first failure
Table 119
Media Card 32-port card faceplate maintenance display codes
Copyright © 2003–2008, Nortel Networks
.
Normal code Fault code
T:13
T:14
T:15
T:16
T:17
T:18
T:19
T:20
Normal code Fault code
T:00
T:01
T:02
T:03
T:04
T:05
T:06
T:07
T:08
T:09
T:10
T:11
T:12
T:13
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
Faceplate maintenance display codes 439
Message
F:13 Programming DS30 FPGA
F:14 Programming CEMUX FPGA
F:15 Programming DSP FPGA
F:16 Testing CEMUX interface
F:17 Testing EEPROM
F:18 Booting processor, waiting for response
with self-test information.
F:19 Waiting for application start-up
messages from processor.
CardLAN enabled, transmitting BootP
requests. If this display persists, then
the ITG-P 24-port line card is running in
BIOS ROM mode due to card software
failure.
Message
F:00 Initialization
F:01 Testing Internal RAM
F:02 Testing ALU
F:03 Testing address modes
F:04 Testing watchdog
F:05 Testing 8051 coprocessor
F:06 Testing timers
F:07 Testing external RAM
F:08 Testing dongle
F:09 Programming timeswitch FPGA
F:10 Programming ISPDI FPGA
F:11 Testing host dual port RAM
F:12 Testing DS-30 dual port RAM
F:13 Testing SEEPROM