Procedure 18 Configuring The Elan Network Interface Ip Address For The Active Elnk - Avaya Nortel Communication Server 1000 Manual

252 Installation and initial configuration of an IP Telephony node
•
Summary of procedures
1.
2.
3.
4.
5.
Configure IP address for the system active ELNK Ethernet network
interface (LD 117)
To configure the Call Server ELAN network interface IP address (active
ELNK), follow the steps in
interface IP address for the active ELNK" (page
Procedure 18
Configuring the ELAN network interface IP address for the active ELNK
Step
1
2
3
4
5
Copyright © 2003–2008, Nortel Networks
.
to be installed. For more information, see Software Input Output
Reference—Maintenance (NN43001-711).
Expand the License limit, if necessary, by ordering additional Licenses.
See "Licenses" (page 44)
"Configure IP address for the system active ELNK Ethernet network
interface (LD 117)" (page
"Configure VoIP bandwidth management zones (LD 117)" (page
"Configure physical TNs (LD 14)" (page
"Configure virtual superloops for IP Phones" (page
"Configure IP Phone features in LD 11" (page
Action
Go to LD 117.
Create host entries with the IP address on the ELAN subnet by
entering one of the following commands:
NEW HOST PRIMARY_IP xx.xx.xx.xx
NEW HOST SECONDARY_IP xx.xx.xx.xx (for Large Systems only)
Assign the host entry IP address to active and inactive ELNK
interfaces on the ELAN subnet by entering one of the following
commands:
CHG ELNK ACTIVE PRIMARY_IP
CHG ELNK INACTIVE SECONDARY_IP (for Dual CPU only)
Verify the IP address for the Ethernet network interface by entering
the following command: PRT ELNK.
Enter the following command: Update DBS.
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
for more information.
252).
256).
Procedure 18 "Configuring the ELAN network
253).
259).
261).
252).