Procedure 16 Installing The Ntmf94Ea Elan, Tlan, Serial Interface Cable - Avaya Nortel Communication Server 1000 Manual

248 Installation and initial configuration of an IP Telephony node
Procedure 16
Installing the NTMF94EA ELAN, TLAN, serial interface cable
Step
1
2
3
4
Copyright © 2003–2008, Nortel Networks
.
WARNING
Plug all Voice Gateway Media Card ELAN network interfaces
belonging to the same node into the same ELAN hub or Layer 2
switch port group.
Action
On Large Systems, connect the NTMF94EA ELAN, TLAN, and
RS-232 Serial Maintenance I/O cable to the I/O panel connector
for the left hand card slot.
For Small Systems, connect the cable to the I/O connector in the
cabinet that corresponds to the IP Line card slot (see
"NTMF94EA ELAN, TLAN and RS-232 serial maintenance I/O
cable" (page 532)).
Connect a shielded CAT5 Ethernet cable from the customer TLAN
Layer 2 or Layer 3 switch port to the RJ-45 port labeled "TLAN".
Connect a shielded CAT5 Ethernet cable from the customer ELAN
Layer 2 or Layer 3 switch port to the RJ-45 port labeled "ELAN".
Install the NTAG81CA serial cable into the faceplate Maintenance
port. This connection is used to configure the IP address for Leader
0. If required, use the NTAG81BA maintenance extender cable.
Alternatively, for a permanent connection to the maintenance port,
use the DB9 female connector on the NTMF94BA breakout cable
to connect a modem (using a null modem) or directly to a local
TTY terminal.
WARNING
The serial maintenance ports presented at the faceplate
and at the backplane are identical. Do not connect a
terminal to both access points simultaneously. This results
in incorrect and unpredictable operation of the Voice
Gateway Media Card.
The switch LEDs and the faceplate link LEDs light when the card is
connected to the WAN/LAN through the TLAN network interface.
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
Figure 108