Replacing The Ipsi Circuit Pack; Re-Assigning A Static Ip Address On The Ipsi Circuit Pack - Avaya S8500 Series Job Aids For Field Replacements

Job Aid: Replacing the IP Server Interface

Replacing the IPSI circuit pack

ELECTROSTATIC ALERT:
Be sure to wear a grounded wrist strap, stand on an approved mat, or work on a
ELECTROSTATIC ALERT:
treated surface that will reduce the possibility of electrostatic discharge.
To replace the IPSI circuit pack:
1. Remove the new IPSI circuit pack from its protective packaging.
2. Slide the circuit pack into the slot all the way into the carrier and latch.
3. Release the circuit pack (release ipserver-interface location).
4. Go to either section:

Re-assigning a static IP address on the IPSI circuit pack

l
Assigning DHCP addressing
l
Note:
The 4-character LED on the IPSI circuit pack's faceplate is used to display the
Note:
circuit pack status related to the Ethernet interfaces. If automatic IP address
assignment via DHCP is enabled, the top character displays the Switch ID and
the next two characters display the Cabinet Number. The last character is used to
display the link status of the two Ethernet interfaces.
Re-assigning a static IP address on the IPSI circuit pack
If the replacement TN2312AP or TN2312BP (IPSI) circuit pack has previously had a static
address programmed, you must erase the existing IP address before re-assigning a new one.
!
CAUTION:
Failure to erase the existing IP address before re-using the IPSI circuit pack can
CAUTION:
create serious network problems.
To set a static IP address on the replacement IPSI circuit pack:
1. Plug the circuit pack into the appropriate slot in the media gateway or if already plugged in,
reseat it (unplug and replug).
2. Wait until the first letter (Switch ID) and the first (cabinet) digit on the LED display stops
flashing (approximately 10 seconds), then press the recessed pushbutton on the faceplate
to change the second digit to 0.
The LED display should now read A00.
164 Job Aids for Field Replacements (FRUs) for the Avaya S8500 Server