Nn43100-500 02.02 Standard Release 5.5 4 February - Avaya Nortel Communication Server 1000 Manual
Ip line fundamentals
Hide thumbs
Also See for Nortel Communication Server 1000:
- Reference (700 pages) ,
- Configuration manual (350 pages) ,
- Hardware installation and maintenance (262 pages)
Table of Contents
Advertisement
394 IP Line administration using Element Manager
8
9
10
11
12
13
Copyright © 2003–2008, Nortel Networks
.
i.
H323 ID: The H323 ID in IP Line is for the Virtual Office/ MG
1000B feature. Keep the H323 ID the same for all the elements
within one node.
j.
Enable Line TPS check box: Select this check box.
k. Add Primary Call Server IP address. Add Alternate Call
Server1 IP address and Alternate Call Server2 IP address, if
applicable.
To add additional cards to the node, click the Add button again and
enter the new card information. Repeat this step for each card to be
added to the node.
Observe that new cards appear under the Cards section as they
are added.
Click the Save and Transfer button after the card have been added
and configured.
Clicking the Save and Transfer button saves the data to the Call
Server.
Click OK to confirm.
The Save and Transfer button can be clicked after each card
is configured in the Edit window. However, each time the Save
and Transfer button is clicked, the Edit window closes and the
Node Configuration window is displayed. To continue the node
configuration, click the Edit button to return to the Edit window.
If the Cancel button is clicked, all information that has been
configured is discarded. The Edit window closes and the Node
Configuration window appears.
The Edit window closes, and the Node Configuration window
appears.
Click the Transfer/Status button associated with the node where
the new card was added.
Click OK to confirm the transfer.
The Transfer Progress window appears and displays each of the
Voice Gateway Media Card in the node.
The Voice Gateway Media Card retrieve the CONFIG.INI and
BOOTP.TAB files from the Call Server. A check mark is added to
each field as the card receives its CONFIG.INI and BOOTP.TAB files.
When the transfer is complete, click OK in the Progress Check
Complete dialog box.
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
Advertisement
Table of Contents
