Avaya Nortel Communication Server 1000 Manual page 243

2
3
Installing the NTCW84JA ITG-specific I/O Panel filter connector for
a Large System
For Large Systems, the standard IPE module I/O filtering is provided
by the 50-Pin filter connectors mounted in the I/O Panel on the back of
the IPE shelf. The filter connector attaches externally to the MDF cables
and internally to the NT8D81AA Backplane to the I/O Panel ribbon cable
assembly.
For 100BaseTX TLAN operation, the standard I/O filter connector must
be replaced with the NTCW84JA ITG Line-specific I/O filter connector for
the following:
•
•
Copyright © 2003–2008, Nortel Networks
.
Use the information from the
summary sheet" (page
by module type" (page
Table 74
Media Card installation by module type
CS 1000 Modules
NT8D37BA/EC IPE modules
NT8D37AA/DC IPE modules
Remove any existing I/O panel cabling associated with any card
previously installed in the selected card slot.
Insert the Media Card into the card guides and gently push it until
it makes contact with the backplane connector. Hook the locking
devices.
The red LED on the faceplate remains lit until the card is configured
and enabled in the software, at which point the LED turns off.
The card faceplate display window displays start-up self-test results
(T:xx) and status messages. A display "F:xx" indicates a failure of
the self-test. Some failures indicate that the card must be replaced.
See "Transfer node configuration from Element Manager to the Voice
Gateway Media Cards" (page
32-port card faceplate maintenance display codes" (page 439)
listing of the Media Card display codes.
the leftmost of the two card slots occupied by the ITG-P 24-port line card
the slot occupied by the Media Card
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
Install the hardware components 243
"Voice Gateway Media Card installation
232), and Table 74 "Media Card installation
243).
Media Card
All available IPE card slots
0, 4, 8, and 12
301). See Table 119 "Media Card
—End—
for a