Avaya Nortel Communication Server 1000 Manual page 404

404 IP Line administration using Element Manager
7
8
9
Copyright © 2003–2008, Nortel Networks
.
d. In the Trap Destinations section, enter the IP address of the trap
destinations. SNMP traps are sent to the IP address entered. A
maximum of eight IP addresses can be configured.
e. Click Save.
The parameters are automatically synchronized with the Call
Server, Signaling Server, Voice Gateway Media Cards, and
Media Gateway Controller.
You should perform an Equipment Data Dump (EDD) to save the
configured information permanently.
After the parameters are synchronized, the associated host route
entries are added to the routing table automatically. If a trap
destination is removed, the corresponding routing table entry
is removed as a result.
In the Element manager navigator, click IP Network > Nodes:
Servers, Media Cards.
The Node Configuration window appears.
Click the Edit button for the node that is having the IP address
changes.
The Edit window appears.
Enter the following Embedded LAN (ELAN) configuration settings:
a. Call Server IP address: This is the IP address of the Call
Server on the ELAN subnet. Enter the Call Server ELAN network
interface IP address (Active ELNK).
The Call Server ELAN network interface IP address must
correspond to the Active ELNK IP address configured in LD 117.
It must be on the same subnet as the ELAN IP address for the
IP Line node.
b. Survivable Media Gateway IP address: This is the IP address
of the Survivable Media Gateway on the ELAN subnet.
The Survivable Media Gateway IP address must correspond to
the Active ELNK IP address. If configured, all Voice Gateway
Media Cards in the same node should be in the same Survivable
Cabinet.
The Survivable Media Gateway associated with the primary
Signaling Server IP Telephony node is called the Alternate Call
Server. It is usually located in the same equipment rack with
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
ATTENTION