Avaya Nortel Communication Server 1000 Manual page 124

124 Features
No configuration is required for the Echo Servers to work. The default
IP address of 0.0.0.0 means that Echo Server 1 uses the TLAN network
interface IP address. The default IP address of 0.0.0.0 means that Echo
Server 2 uses the Node IP address.
An IP address of 0.0.0.0 means the default local Echo Server is enabled.
The NAT Traversal feature is essentially automatic. Changing the IP addresses or
ports must only be done in exceptional cases when an Echo Server external to
the CS 1000 system is used.
If IP addresses are specified, they must be for servers external to the
system. The IP addresses cannot be the same. Duplicate IP addresses
can only be used if the default of 0.0.0.0 is used. If the IP addresses are
the same (and not 0.0.0.0), an error message is generated and the input
is not accepted.
Table 31
LD 117 commands for NAT
Command
CHG ES1 <Echo Server 1 IP
Address> <Echo Server 1 Port>
CHG ES2 <Echo Server IP
Address> <Echo Server Port>
PRT ES1
PRT ES2
PRT ESS
Copyright © 2003–2008, Nortel Networks
.
ATTENTION
Description
Change Echo Server 1 IP address and port number, where:
• Default Echo Server 1 IP Address = 0.0.0.0
• Default Echo Server 1 Port number = 10 000
Echo Server 1 default IP address uses the TLAN IP
address of the LTPS.
Change the Echo Server 2 IP address and port number,
where:
•
Default Echo Server 2 IP Address = 0.0.0.0
• Default Echo Server 2 Port number = 10 000
Echo Server 2 default IP address uses the node IP address
on the node master card.
Print Echo Server 1 IP address and port number.
Print Echo Server 2 IP address and port number.
Print both Echo Servers IP addresses and port numbers.
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008