Finding The Active Media Server Ip Address; Maintenance Web Interface; Command Line Interface - Avaya S8700 Installation Instructions Manual

Accessing the media server
2
When the "Start PPP now!" message appears, click
Complete dialog box, your computer is connected to the media server.
3
To open a Telnet session, click Start > Run to open the Run dialog box.
4
In the Run dialog box, type
actual active media server.
5
To use Avaya Site Administration, launch the software and select the switch you want to dial into.
See Installing Avaya Site Administration
and build a record for a particular media server.

Finding the active media server IP address

1
To get the IP address of the actual active media server, go to the task bar at the bottom right of
your PC screen.
2
Right-click on the Network Status icon, and select Status, then the Details tab.
3
Scroll down until you see the Server IP address. This is the IP address for the media server you are
connected to.

Maintenance Web Interface

You can access the Maintenance Web Interface either by connecting directly to the services port (port 2
[Eth1]) on the media server (see
Media Server,
Internet Explorer 5.5 or 6.0.
When connected directly to the media server, you also must disable all proxy servers.
1
Click Tools > Internet Options.
2
Select the Connection tab.
3
In the LAN Settings box (lower right-hand), check "Bypass proxy server for local addresses."
4
Click OK, OK.
To use the Maintenance Web Interface:
1
Open the MS Internet Explorer Web browser.
•
•
2
When prompted, log in.

Command line interface

Telnet: To use a command line interface in a Telnet window:
1
Click Start > Run to open the Run dialog box.
•
258
telnet IPaddress
Figure 100, Services laptop computer connected directly to the S8700
on page 256) or connecting over the customer's network. The browser supported is the MS
If a direct connection, in the
If a remote connection, in the
name of the specific media server.
If a direct connection, type
Installing the Avaya S8700 Media Server with an Avaya G650 Media Gateway
. When you see the Connection
Done
and click OK, where IPaddress is the address of the
on page 260 for information on installing the software
Location/Address field, type
field, type in the IP address or DNS host
Location/Address
and click OK.
telnet 192.11.13.6
192.11.13.6 .
December 2003