Basic Function; Functions And Panel Layout - Kenwood TK-3180 Function Reference

1 BASIC FUNCTION

1.1

Functions and Panel Layout

1.1.1 TK-2180/ 3180
Figure 1-1 TK-2180/ 3180 Front View
Antenna
This is the transceiver's antenna.
Selector
You can configure the Zone and CH/GID using this
selector.
Power Switch/Volume Control
You can turn the transceiver ON by rotating this
switch. The Volume control allows you to adjust the
volume level of the speaker.
TX LED/BUSY LED
These LEDs light when sending or receiving a signal
(Refer to 3 DISPLAY.)
Side 1 key
You can activate the assigned function with this key.
PTT switch
Press this switch to transmit.
Microphone
This is the transceiver's microphone.
Side 2 key
You can activate the assigned function with this key.
Version: 1.11
AUX key
You can activate the assigned function with this key.
Speaker
The speaker emits the received audio signals and
alert tones.
LCD Display
The channel number and the transceiver's status
appear on this display.
PF keys
Press any key to activate a function assigned to each
function key.
Keypad
Press any key to activate a function assigned to each
function key or enter the number.
(12 Keypad models only)
1.1.2 TK-7180/ 8180
Figure 1-2 TK-7180/ 8180 Front View
Power Switch
Press this switch to turn the transceiver ON and press it
again to turn it OFF.
[ ]/[ ] key
The Volume control allows you to adjust the volume
level of the speaker.
You can activate the assigned function with this key.
[ ]/[ ] key
The channel number and the transceiver's status
appear on this display.
You can activate the assigned function with this key.
[Up]/[Down] key
You can configure the Zone and CH/GID using this
selector.
Speaker
The speaker emits the received audio signals and
alert tones.
TX LED/BUSY LED
These LEDs light when sending or receiving a signal.
(Refer to 3 DISPLAY.)
Microphone connector
You can connect a microphone using this connector.
Function Reference
J A B C
1