Status 80 - 99 (Special); Emergency Status Response; Short Message Function; Sending The Short Message - Kenwood TK-3180 Function Reference

!
Configuration using KPG-89D
•
Configuring the Target Fleet (Refer to FPRG
6.12.7 Target tab - Target Fleet.)
• Configuring the Target ID (Refer to FPRG 6.12.7
Target tab - Target ID.)

22.3.13 Status 80 - 99 (Special)

Status No. 80 - 99 (reserved status) are used for
transceiver specified operations. You can lock these
statuses to prevent a user from sending them by mistake.
You can enable/disable the Status No. 80 - 99 (Special)
transmission using KPG-89D.
!
Configuration using KPG-89D
•
Configuring the Status No.80 - 99 (Special) (Refer
to FPRG 6.12.1 General 1 tab - Status No. 80 - 99
(Special).)

22.3.14 Emergency Status Response

Emergency Status Response is the transceiver's
operation when receiving the Emergency Status.
"MAN DOWN" appears on the display when the
transceiver receives the Status 98. "EMERGENCY"
appears on the display when the transceiver receives the
Status 99. However, the configured data appears when
emergency status is configured in the Status List.
You can configure the following functions for the
Emergency Status Response using KPG-89D.
Table 22-11 Emergency Status Response operation
Emergency Status
Response
None The transceiver works as normal.
Alert Tone configured in the Emergency
Status sounds when receiving the
Alert Emergency Status. Press any key other
than the Volume Up/Down key to stop
Alert Tone.
The Horn Alert terminal is activated
when receiving the Emergency Status.
The operation of the Horn varies
Horn
according to the Horn Alert
configuration. The operation of the Alert
is also enabled.
!
Configuration using KPG-89D
• Configuring the Emergency Status Response
(Refer to FPRG 6.12.1 General 1 tab - Emergency
Status Response.)
Version: 1.11
Operation
Function Reference

22.4 Short Message Function

This function allows the transceiver to transmit/receive a
maximum of 48 characters.
With this function, you can reliably send information to the
transceiver.

22.4.1 Sending the Short Message

You can send the Short Message from a PC. A user is
not allowed to send a Short Message from the
transceiver.
!
Transceiver Operation
1. Send the serial command to the transceiver from
the PC.
The transceiver sends the Short Message.
TK-2180/ 3180
TK-7180/ 8180
22 FLEETSYNC
107