2 BASIC OPERATION
TK-2180/ 3180
TK-7180/ 8180
The CH/GID Name or Zone-CH/GID number
appears on the display.
Character.)
TK-2180/ 3180
TK-7180/ 8180
!
When no Data is Written to the Transceiver:
1. Press the Power switch.
"UNPROGRAM" appears on the LCD when turning
the transceiver ON.
TK-2180/ 3180
TK-7180/ 8180
12
(Refer to 3.6.5 Display
Function Reference
2.1.2
Turning the Transceiver OFF
Press the Power switch to turn the transceiver OFF.
You can also turn ON/OFF the transceiver using the
Ignition Sense function.
2.2
Adjusting the Volume
You can increase the Volume level by turning the Volume
control clockwise and decrease it by turning the control
counterclockwise for the TK-2180/ 3180.
Press [
] to increase the volume or [
the volume for the TK-7180/ 8180.
2.3
Using Function Keys
Press a key to activate a function assigned to each
function key.
(Refer to 10 Key Assignment.)
2.4
Changing the Zone
You can change the Zone number using the Selector, the
PF Zone Up key, and the PF Zone Down key.
Although scan pauses if you change the Zone number
during scan, the Transceiver resumes scanning after 1
second.
The transceiver skips Zone numbers that are not
configured when changing the Zone number.
The Rollover Tone sounds when the Zone Number
reaches the lowest number.
!
Transceiver Operation
# Using the Selector
•
Turn the Selector clockwise.
The Zone number increases in steps of 1.
•
Turn the Selector counter-clockwise.
The Zone number decreases in steps of 1.
# Using PF keys
•
Press the PF Zone Up key.
The Zone number increases in steps of 1.
•
Press and hold the PF Zone Up key for more
than one second.
The Zone number increases in steps of 1 every
200 ms.
•
Press the PF Zone Down key.
(Refer to 8 Ignition Sense.)
] to decrease
Version: 1.11