Selectable Tone Level; Alert Tone Pattern; Ptt Release Tone - Kenwood TK-3180 Function Reference

4.6

Selectable Tone Level

This function allows you to adjust the Tone Volume using
the PF key.
The volume level of the tone is configured to the Optional
Features window the Common - Page2 tab - Low Volume
Level (Fixed Volume) or High Volume Level (Fixed
Volume) by pressing the PF Fixed Volume key.
You can configure the Selectable Tone Level using KPG-
89D
!
Transceiver Operation
1. Press the PF Fixed Volume key.
The volume of the tone changes.
The tone volume changes in the following way.
Low Volume Level (Fixed Volume) - High Volume
Level (Fixed Volume) - Off
!
Configuration using KPG-89D
• Configuring the Low Volume Level (Fixed Volume)
(Refer to FPRG 6.7.2 Common-Page 2 tab - Low
Volume Level (Fixed Volume).)
• Configuring the High Volume Level (Fixed Volume)
(Refer to FPRG 6.7.2 Common-Page 2 tab - High
Volume Level (Fixed Volume).)
•
Assigning functions to the PF keys (Refer to
FPRG 6.8 Key Assignment.)
4.7

Alert Tone Pattern

This function allows you to configure the Alert Tone
pattern when receiving a call with DTMF/2-tone/
FleetSync. You can select an Alert Tone matching your
environment.
You can select a Alert Tone from eight patterns of Alert
Tones. An Alert Tone pattern consists of 16 tones.
You can configure the Alert Tone Pattern using KPG-89D
Below is a list of configuration items for the Alert Tone.
Version: 1.11
Alert Tone Pattern
Frequency
Length
Cycle
Interval
!
Configuration using KPG-89D
•
Configuring the Alert Tone Pattern (Refer to FPRG
6.13 Special Alert Tone.)
4.8

PTT Release Tone

The PTT Release Tone sounds after the communication
completes and the PTT switch is released. This tone
notifies the receiving party that the transmission is
finished. With this function, the receiving party can easily
recognize the timing to transmit since the tone sounds
when the caller to finishes transmitting.
The PTT Release Tone is sent prior to end of the
transmission, when the caller releases the PTT switch.
PTT Off
PTT On
Transmit
Receive
Function Reference
Table 4-8 Alert Tone Pattern
Description
You can configure the frequency of
the tone. You can configure the
frequency between 400 and 2500 Hz
in steps of 10 Hz. The Gap can be
configured when selecting "No
Tone".
You can configure the tone length.
You can configure the tone length
between 10 and 2500 ms in steps of
10 ms. No tone is emitted when
selecting 0 ms.
You can configure the number of
times for the Alert Tone to sound.
You can select the numbers from 1
to 255. The Alert Tone is emitted
with no limitation when configuring
the cycle to "Infinite". Any alert tone
does not sound while the transceiver
unmutes when emitting the Alert
Tone several times. The Alert Tone
is disabled when the match status of
2-tone/DTMF/FleetSync is released.
You can configure the interval time
to repeat the Alert tone. You can
configure the time between 0 and
255 s in steps of 1 s.
PTT Release Tone
Figure 4-1 PTT Release Tone
4 SOUND
27