Gps Report Mode; Number Of Times - Kenwood TK-3180 Function Reference

!
Status
The transceiver sends the GPS data with the
FleetSync Status Message.
Status + GPS
Figure 22-2 Timing to Send the GPS Combination (PTT ID)
!
Emergency
The transceiver sends the GPS data with the
Emergency ID (FleetSync).
The GPS data is not added to the DTMF/ANI Board.
Following are the ID to be sent and the GPS data.
Table 22-15 ID and GPS data
Emergency ID (Emergency Information)
Emergency
ID
None
Check
-
(Enable)
Uncheck
-
(Disable)
Emergency + GPS ID GPS
Figure 22-3 Timing for the GPS Combination
!
Configuration using KPG-89D
•
Configuring the GPS Combination (PTT ID) (Refer
to FPRG 6.12.6 GPS tab - GPS Combination (PTT
ID).)
•
Configuring the GPS Combination (Status) (Refer
to FPRG 6.12.6 GPS tab - GPS Combination
(Status).)
• Configuring the GPS Combination (Emergency)
(Refer to FPRG 6.12.6 GPS tab - GPS
Combination (Emergency).)
• Configuring the PTT ID (Refer to FPRG 6.3.12
PTT ID.)
• Configuring the Emergency ID (Refer to FPRG
6.4.19 Emergency ID.)
Version: 1.11
St
GPS
FleetSync DTMF
Board*
FleetSync
DTMF ID
ID + GPS
FleetSync
DTMF ID
ID
ID GPS

22.6.3 GPS Report Mode

This function allows you to select the transmission
method: Transmit the GPS data automatically or transmit
after receiving the command.
Transmit
You can configure the GPS Report Mode using KPG-89D.
The GPS Report Mode has the following functions.
Receive
Table 22-16 GPS Data Request Configuration
GPS Report
Mode
Poll
ANI
Auto
ANI
ANI
!
Configuration using KPG-89D
•
Configuring GPS Report Mode (Refer to FPRG
6.12.6 GPS tab - GPS Report Mode.)
Transmit

22.6.4 Number of Times

Receive
This function allows the transceiver to send the GPS data
for the configured times when "Poll" is selected in GPS
Report Mode.
You can send the GPS data for the configured times at
the interval configured in the GPS Report Interval.
You can configure the number of times to send the GPS
data using KPG-89D.
!
Configuration using KPG-89D
•
Configuring the Number of Times (Refer to FPRG
6.12.6 GPS tab - Number of Times.)
Function Reference
22 FLEETSYNC
Function
The transceiver sends the GPS data when
receiving the GPS data transmission request
from the base station.
This function is used when the base station
controls the timing to send the GPS data.
This allows a user to avoid transmit collision.
The transceiver sends the GPS data at the
interval configured in the GPS Report Interval.
This function is useful for controlling or
monitoring cars as the transceiver frequently
transmits the position data to the base station.
The transceiver sends the GPS data when
receiving the GPS data transmission request
from the base station even if the Auto is
selected.
113