Telephone Interconnect; Connecting To The Phone Line; Auto Telephone Search - Kenwood TK-3180 Function Reference

17 LTR TRUNKING

17.4 Telephone Interconnect

In LTR Trunking Systems, you can connect to the PSTN
(Public Switched Telephone Network) via the RIC
(Repeater Inter Connect).

17.4.1 Connecting to the Phone Line

To make a phone call using the transceiver, you must use
a microphone with a keypad. However, the microphone
with a keypad is not required to make a phone call when
using the Autodial function.
!
Transceiver Operation
# Connecting to the Phone Line Using the Auto
Telephone Function
1. Select the phone number you want to call using
the Autodial function.
(Refer to 20 DTMF.)
2. Press [S2].
The transceiver is automatically connected to
the phone line.
A user cannot dial the phone number by
pressing the PF Auto Telephone key if no
number is configured, even though the
transceiver enters the Off-hook status (dial tone
standby). While the transceiver receives the dial
tone, you can transmit the phone number using
the Manual Dialing function or the Keypad Auto
PTT function.
# Connecting to the Phone Line using the PTT
Switch
1. Select the GID that the Telephone ID is
configured.
The " " icon appears.
2. Select the phone number to call using the
Autodial function.
(Refer to 20 DTMF.)
3. Press the PTT switch.
The transceiver is connected to the phone line.
The transceiver is connected to the phone line
when the PTT switch is pressed while the GID
that the Telephone ID is configured. In this
case, the transceiver enters Off-hook status
(dial tone standby). While the transceiver
receives the receiving tone, the user can
transmit the phone number using the Manual
Dialing function or the Keypad Auto PTT
function.
# Disconnecting the Phone Line
1. Press [#] or the PF Disconnect key during
communication.
The transceiver is disconnected from the phone
line.
64
!
Configuration using KPG-89D
•
Assigning functions to the PF keys (Refer to
FPRG 6.8 Key Assignment.)

17.4.2 Auto Telephone Search

This function allows the transceiver to search for an
available RIC repeater and automatically connects the
transceiver to the repeater.
The transceiver automatically searches for an available
telephone interconnect line to make a call. This function
is similar to the memory dial function of a mobile phone,
allowing the user to easily make a call.
Zones satisfying the following conditions are targeted for
the search. When no Zone matches these conditions, the
Deny Tone sounds and the Auto Telephone Search
function does not operate.
• At least, 1 Zone is in the Auto Telephone Search list.
•
There is a RIC repeater in the above Zone.
•
There is a Group ID having the LTR ID configured as
the Encode ID used to connect to a phone line in the
above Zone.
!
Transceiver Operation
1. Press the PF Auto Telephone key.
The "AUTO TEL" appears on the Main Display and
the "
The transceiver starts the Auto Telephone Search.
TK-2180/ 3180
TK-7180/ 8180
Function Reference
" icon blinks.
Version: 1.11