Basic Operations; Switching Power On/Off; Adjusting The Volume; Selecting A Zone And Channel/Group Id - Kenwood NX-700 Instruction Manual

SWITCHING POWER ON/OFF

Press and hold the
power ON. Press and hold the
■ Transceiver Password
If the transceiver is password protected, "PASSWORD" will appear on the
display when the power is turned ON. To unlock the transceiver, enter the
correct password:
1 Select a character using the
• If you are using a microphone keypad, you can enter the password by direclty
pressing the DTMF keys instead.
2 Press the
• This step is unnecessary when using a keypad.
3 Repeat steps 1 and 2 to enter the entire password.
• Press the
Press and hold the
4 Press the
• If you enter an incorrect password, an error tone sounds and the transceiver
remains locked.
• The password can contain a maximum of 6 digits.

ADJUSTING THE VOLUME

Press the keys programmed with Volume Up/ Volume Down to adjust the volume
level.

SELECTING A ZONE AND CHANNEL/GROUP ID

Select the desired zone using the keys programmed as Zone Up/ Zone Down.
Each zone contains a group of channels.
Select the desired channel/group ID using the keys programmed as CH/GID Up /
CH/GID Down. Each channel/group ID is programmed with settings for
transmitting and receiving.
Names can be programmed for zones and channels/group IDs. Each name can
contain up to 14 characters.
• You can toggle the display between the zone and channel/group ID names and number
by pressing the key programmed as Display Format, or by accessing the Display Format
function through the Menu {page 12}.

BASIC OPERATIONS

switch for approximately 1 second to turn the transceiver
switch again to turn the transceiver OFF.
key to enter the selected character.
key or microphone # key to delete an incorrectly entered character.
key or microphone # key to delete all characters.
key or microphone
and keys.
key to confi rm the entry.
9