# Using the Keypad
•
Enter the ID using [0] - [9].
# Deleting the entered character
•
Press [A] - [#].
The selected character is deleted.
•
Press and hold [A] - [#].
All characters are deleted.
TK-2180/ 3180
TK-7180/ 8180
4. Press the PTT switch to make a voice call.
Press [Side 2]/ [!] to make a paging call.
Press [S] to enter the Status Message. (Only
when the transceiver enters Status Message
Entry Mode using the PF Selcall + Status key.)
(Refer to 22.3 Status Message Function.)
22.2.2 Receiving a Selective Call
The transceiver enters the Reception Display Mode when
receiving a Selective Call.
The condition for the FleetSync ID to match is as follows.
Table 22-4 Call TypeConditions to Unmute
Call Type
Fleet
fff: 100 - 399
Individual Call
Match
Group Call
Match
Fleet Call
Match
Supervisor Call
ALL Fleet
Broadcast Call
ALL Fleet
Note: You must select "FleetSync" in the "Optional Signaling" in
the Channel Edit window or the GID Edit window.
Version: 1.11
Conditions to Unmute
ID
iiii: 1000 - 4999
Match
Group ID matches.
ALL ID
Match
ALL ID
!
Individual Call/ Group Call
A user can respond to the party that appears on the
display by pressing the PTT switch or [Side 2]/ [!].
The transceiver controls the mute function only and
does not move to the Call Mode for the following
condition.
•
The transceiver receives a call from the Fleet
inhibited with the Interfleet configuration.
•
The receive ID is not registered in Data Encode
Block ID.
•
The transceiver receives a call having the ID that
the TX Inhibit function is enabled in the Selcall List.
The display returns to normal when a key is pressed.
The display returns to the last display after the Auto
Reset Timer expires if the Auto Reset Timer is
configured.
# When the ID is registered in the ID List
(Individual Call):
TK-2180/ 3180
TK-7180/ 8180
# When no ID is registered in the ID List
(Individual Call):
TK-2180/ 3180
TK-7180/ 8180
Function Reference
22 FLEETSYNC
97