Gps Data Storage; Reading From Gps Data Storage - Kenwood TK-3180 Function Reference

The transceiver activates the Voice Guide function in
the following status and emits the following announce.
Table 31-4 Status of the Transceiver and Voice Type
Category Status
Operating the
Transceiver transceiver while the
Password Transceiver Password
function is enabled.
Operating the
transceiver while the
Key Lock
Key Lock function is
enabled.
Message
Selecting the Message
Playback
Selecting the SelCall
List using the Selector
or [Up]/ [Down].
Selecting the Status
FleetSync List using the Selector
or [Up]/ [Down].
The Status Message is
not properly sent to the
receiving party.
Note: The Key Beep A/ B does not sound when the Voice Guide is
enabled.
!
Configuration using KPG-89D
• Configuring the Zone-CH/GID Guide (Refer to
FPRG 6.7.6 VGS-1 tab - Zone-CH/GID Guide.)
• Configuring the Function Guide (Refer to FPRG
6.7.6 VGS-1 tab - Function Guide.)
Version: 1.11
Voice Type
Radio Locked
Key Locked
"Clock" - "Message
Type"
Example:
"ten-thirty AM Voice
memo"
"twelve-eleven PM
Reply Message"
ID List "Number"
Example:
"ID List fourty-three"
Status List Number
Example:
Status List sixty-eight
Message denied
Function Reference

31.6 GPS Data Storage

(TK-7180/ 8180 only)
This function allows the transceiver to store the FleetSync
GPS data in the VGS-1. The transceiver can store the
FleetSync GPS data in the VGS-1 for each Data Storage
Cycle.
The transceiver can store a maximum of approximately
10000 GPS data (10752 Messages).
You can transmit the GPS data to another station or read
it with a PC.
31.6.1 GPS Data Storage
(TK-7180/ 8180 only)
The GPS data is written to the VGS-1 at the cycle
configured in the Data Storage Cycle.
You can configure the GPS Data Storage and the Data
Storage Cycle using KPG-89D.
Note:
" The GPS data is written to the VGS-1 when the transceiver
receives valid data from the GPS Unit.
" The GPS data is not stored when one or more of Recording
Mode, Voice Memo Mode, Auto Reply Message, and Message
Playback is enabled.
!
Configuration using KPG-89D
• Configuring the GPS Data Storage (Refer to
FPRG 6.7.6 VGS-1 tab - GPS Data Storage.)
• Configuring the Data Storage Cycle (Refer to
FPRG 6.7.6 VGS-1 tab - Data Storage Cycle.)
31.6.2 Reading from GPS Data
Storage
You can read the GPS Data Storage with the following
methods.
!
Reading GPS Data using the Air Function
The transceiver requests the data to the base station
using the FleetSync protocol. The mobile transceiver
equipped with the VGS-1 sends the GPS data stored
in the VGS-1 when receiving the reception request.
Note:
" The mobile transceiver must send the data written in the
VGS-1.
" The mobile station does not send data to the base station
even if it receives the latest data from the GPS Unit while
transmitting. The transceiver sends data upon receiving the
GPS data.
31 VGS
163