Cor; Tor; Aux A; Aux B - Kenwood TK-3180 Function Reference

26 FUNCTION PORT

26.2.2 COR

This port notifies a user that the transceiver is receiving a
Carrier.
This port becomes active when receiving a Carrier.
Otherwise, this port is inactive.

26.2.3 TOR

This port notifies a user that the transceiver is receiving
the GID in a Trunking system and QT/ DQT is matched in
Conventional Groups.
This port becomes active when receiving a call with GID
in a Trunking system. Otherwise, this port is inactive.
This port becomes active when receiving a carrier on the
channel that the QT/DQT is configured in Conventional
Groups. Otherwise, this port is inactive.

26.2.4 AUX A

The port output changes in conjunction with the PF AUX
A port. A user can control an external device connected
to the PF AUX A port.

26.2.5 AUX B

The port output changes in conjunction with the PF AUX
B port. A user can control an external device connected
to the PF AUX B port.

26.2.6 System Busy

This port becomes active when no repeater is available in
a Trunking system. Otherwise, this port is inactive.

26.2.7 PTT Out

This port notifies a user that the PTT switch is pressed.
You can use this function when an optional board or an
external device is connected to the transceiver.
This port becomes active when the PTT switch is
pressed. Otherwise, this port is inactive.
148

26.2.8 Channel Busy

This port notifies a user that the remote control request
from the external device is rejected.
This port becomes active in the following conditions.
Table 26-5 Conditions for the Channel Busy Port to
Mode
Transmission
Emergency Emergency Mode

26.2.9 COR or Channel Busy

This port becomes active when the COR port or Channel
Busy port is active. When neither of ports is disabled, this
port becomes inactive.
You can use this port to connect the KPG-2A or KDS-100
to the transceiver. With this port, you can restrict the
transmission request to the KPG-2A or KDS-100 when
you do not want the transceiver to be controlled with an
external device.

26.2.10 TOR or Channel Busy

This port becomes active when the TOR port or Channel
Busy port is active. When either of the ports is disabled,
this port becomes inactive.

26.2.11 TXS

This port notifies a user that the transceiver is
transmitting.
This port becomes active when the transceiver is
transmitting. Otherwise, this port is inactive.
26.2.12
This port is used to change the status of the transceiver
when it receives the FleetSync Status Message.
This port switches the Status of the AUX Out port (High >
Low or Low > High) when the received Status Message
matches the Status number configured to the port.
You can configure 2 Statuses (High
to each port since these ports are AUX Output ports.
This port is normally used to remotely control the
transceiver by connecting an external device to the AUX
Out.
Function Reference
Become Active
Status
All transmissions (including automatic
transmission and the transmission using the
PTT switch)

AUX Out Status Message 1 - 3

>
Low or Low
>
High)
Version: 1.11