Panasonic JB-3300 Technical Manual page 108

9.5.6 Test automatically
CRT Displays or
Step Test Procedures Printer Print Outs
1 Type ENTER THE NUMBER TO RUN
into DIAGNOSTIC THE TEST? __
MENU.
2 Key in the You will be asked to press
number of times
you want the
test to be re-
peated (up toa
maximum of
99999) and
press .
various keys and to ensure that
the devices are ready to be
tested throughout the automatic
test. Refer to the "TEST ALL
DEVICES" section for details on
the testing of each device.
Note that the screen display
may differ slightly because you
don't need to press any keys to
move from one test to the next.
To terminate the automatic test
before it is completed, press
the [Break] key while holding
down the [Cntrl] key. The
screen should return to the
diagnostic menu. If not, you
may first have to respond to
the current message on the
screen.
When the instructions below appear on the display follow the instructions.
Attach the loop back plug to the connector.
Press any key when ready __
Insert scratch disk(s) in (all) drive(s)
and strike any key when ready
I - 93