Replace The Drive Hub Oil; Perform Engine Maintenance - Kubota Diesel Models - Genie GS-2669 RT Service Manual

November 2014
D-6

Replace the Drive Hub Oil

Note: Genie specifications require that this
procedure be performed every 1000 hours or
annaully, whichever comes first.
Replacing the drive hub oil is essential for good
machine performance and service life. Failure to
replace the drive hub oil at yearly intervals may
cause the machine to perform poorly and continued
use may cause component damage.
1 Select the drive hub to be serviced. Drive the
machine until one of the two plugs is at the
lowest point.
2 Remove both plugs and drain the oil into a
suitable container.
3 Drive the machine until one of the two plugs is
at the highest point.
a drive hub plugs
4 Fill the hub until the oil level is even with the
bottom of the lowest plug hole. Refer to Section
2, Specifications.
5 Install the plugs into the drive hub.
6 Repeat this procedure for the other drive hub.
Part No. 229753
a
GS-2669 RT • GS-3369 RT • GS-4069 RT
Section 3 • Scheduled Maintenance Procedures
CHECKLIST D PROCEDURES
D-7
Perform Engine Maintenance -
Kubota Diesel Models
Engine specifications require that this procedure be
performed every 1500 hours.
• Inspect injectors
Required maintenance procedures and additional
engine information is available in the
Kubota D1105 Operator's Manual
(Kubota part number 16622-89166).
Kubota D1105 Operator's Manual
Genie part number 131379
3 - 37