Perform Engine Maintenance - Kubota Models - Genie GS-2669 RT Service Manual

November 2014
2 Apply a thin layer of fresh oil to the new oil filter
gasket.
3 Install the new filter and tighten it securely by
hand.
4 Use a permanent ink marker to write the date
and number of hours from the hour meter on
the filter.
5 Clean up any oil that may have spilled during
the replacement procedure.
6 Turn the key switch to ground controls and pull
out the red Emergency Stop button to the on
position at both the ground and platform
controls. Start the engine.
7 Raise the platform approximately 3 feet / 1 m.
8 Inspect the filter and related components to
be sure that there are no leaks.
Part No. 229753 GS-2669 RT • GS-3369 RT • GS-4069 RT
Section 3 • Scheduled Maintenance Procedures
CHECKLIST D PROCEDURES
D-3
Perform Engine Maintenance -
Kubota Models
Engine specifications require that this procedure be
performed annually.
Kubota D1105:
• Replace air filter
Kubota WG972:
• Replace air filter
• Replace fuel lines and clamps
• Clean carburetor
Required maintenance procedures and additional
engine information is available in the
Kubota D1105 Operator's Manual
(Kubota part number 16622-89166) OR the
Kubota WG972 Operator's Manual
(Kubota part number EG801-8916-2).
Kubota D1105 Operator's Manual
Genie part number
Kubota WG972 Operator's Manual
Genie part number
131379
234803
3 - 35