Grease The Turntable Rotation Bearing And Rotate Gear; Replace The Drive Hub Oil - Genie S-80 Service Manual

Service Manual
Checklist A Procedures
A-12
Grease the Turntable Rotation
Bearing and Rotate Gear
Genie specifications require that this procedure be
performed every 100 hours of operation.
Perform this procedure more often if dusty
conditions exist.
Frequent application of lubrication to the turntable
bearing and rotate gear is essential to good
machine performance and service life. Continued
use of an improperly greased bearing and gear will
result in component damage.
1 Locate the grease fitting for the turntable
rotate bearing.
2 Pump grease into the turntable rotation
bearing. Rotate the turntable in increments of
4 to 5 inches / 10 to 13 cm at a time and repeat
this step until the entire bearing has been
greased.
3 Apply grease to each tooth of the drive gear,
located under the turntable.
Grease Specification
Chevron Ultra-duty grease, EP NLGI 1 (lithium based)
or equivalent
28
A-13

Replace the Drive Hub Oil

Drive hub specifications require that this one-time
procedure be performed after the first 150 hours of
usage. After this interval, refer to the maintenance
checklist for continued scheduled maintenance.
Replacing the drive hub oil is essential for good
machine performance and service life. Failure to
replace the drive hub oil at yearly intervals may
cause the machine to perform poorly and continued
use may result in component damage.
1 Refer to Section D Maintenance Procedure,
Replace the Drive Hub Oil.
S-80 • S-85 • S-80X
February 2017
Part No. 1259369GT