Genie GS-2669 RT Service Manual page 78

Section 4 • Repair Procedures
SCISSOR COMPONENTS
10 Using a soft metal drift, remove the pivot pins
and set aside.
11 Carefully lift the linkage assembly off of the
machine and place it on a structure capable of
supporting it.
12 Using an overhead lifting device attach a 4 hook
sling chain to the ends of the number 2 inner
arm (index #14). Make the chains tight but do
not apply lifting pressure.
Crushing hazard. The linkage
assembly could become
unbalanced and fall if not properly
supported when removed from the
machine.
13 Remove the retaining fasteners from the number
2 pivot pins (index #6 and #16).
Note: Do not remove the external snap ring.
14 Using a soft metal drift, remove the pivot pins
and set aside.
4 - 8 GS-2669 RT • GS-3369 RT • GS-4069 RT
15 Carefully lift the linkage assembly off of the
machine and place it on a structure capable of
supporting it.
16 Tag and disconnect the harness from the lift
cylinder valve block.
17 Tag and disconnect the hydraulic hoses from
the lift cylinder. Plug the hoses and cap the
fittings.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to squirt
or spray.
18 Remove the hose clamps and hoses from the
number 1 inner arm.
19 Using an overhead lifting device attach a 4 hook
sling chain to the ends of the number 1 inner
arm (index #8). Make the chains tight but do not
apply lifting pressure.
Crushing hazard. The linkage
assembly could become
unbalanced and fall if not properly
supported when removed from the
machine.
November 2014
Part No. 229753