Level Sensor - Models Without Outriggers - Genie GS-2669 RT Service Manual

Section 4 • Repair Procedures
GROUND CONTROLS
12 Use the yellow platform down arrow to scroll to
outriggers option.
Result:
OUTRIGGERS ON
diagnostic display window. Press the lift
function enable button to activate or deactivate
the outrigger option. Proceed to step 18.
Note: For this option to function correctly, the
machine must be equipped with the required
outrigger components and the software set to
or
OUTRIGGERS AUTO OUTRIGGERS ON
13 Use the yellow platform down arrow to scroll to
return to the main menu.
Result:
RETURN TO MAIN MENU
diagnostic display window.
14 Press the lift function enable button.
Result:
SELECT OPTIONS
diagnostic display window.
15 Push in the red Emergency Stop button to the
off position at the ground controls.
4 - 40
is showing in the
.
is showing in the
is showing in the
GS-2669 RT • GS-3369 RT • GS-4069 RT
7-4
Level Sensor -
Models without Outriggers
The Electronic Control Module (ECM) is
programmed to deactivate the lift and drive
functions and activate an alarm when a signal is
received from the level sensor.
The tilt alarm sounds when the incline of the
chassis exceeds 2° to the side and 3° to the front
or rear.
How to Install and Calibrate the
Level Sensor
Tip-over hazard. Failure to install
or calibrate the level sensor as
instructed could result in the
machine tipping over causing
death or serious injury. Do not
install or calibrate the level sensor
other than specified in this
procedure.
Note: Perform this procedure with the machine on
a firm, level surface and the platform in the stowed
position. Use a digital level to confirm.
1 Remove the platform controls from the platform.
If you are not installing a new level sensor,
proceed to step 9.
2 Locate the level sensor in the ground controls
compartment.
November 2014
Part No. 229753