Genie GS-2669 RT Service Manual page 34

Section 3 • Scheduled Maintenance Procedures
MAINTENANCE INSPECTION REPORT
Model
Serial number
Date
Hour meter
Machine owner
Inspected by (print)
Inspector signature
Inspector title
Inspector company
Instructions
• Make copies of this report to use for
each inspection.
• Select the appropriate checklist(s) for
the type of inspection to be
performed.
Daily or 8 hours
Inspection:
Quarterly or 250 hours
Inspection:
Semiannually or 500 hours
Inspection:
Annually or 1000 hours
Inspection:
Two year or 2000 hours
Inspection: A+B+C+D+E
• Place a check in the appropriate box
after each inspection procedure is
completed.
• Use the step-by-step procedures in
this section to learn how to perform
these inspections.
• If any inspection receives an "N", tag
and remove the machine from
service, repair and reinspect it. After
repair, place a check in the "R" box.
Legend
Y = yes, acceptable
N = no, remove from service
R = repaired
3 - 6
Checklist C
C-1 Platform overload
(if equipped)
C-2 Down limit switch delay
(if equipped)
C-3 Fuel tank -
Diesel models
C-4 Breather cap - models
with optional oil
C-5 Engine maintenance -
Diesel models
Perform every 800 hours:
C-6 Engine maintenance -
Kubota diesel models
Checklist D
D-1 Scissor arm wear pads
D-2 Hydraulic filter
D-3 Engine maintenance -
Kubota models
D-4 Engine maintenance -
Perkins models
A
D-5 Engine maintenance -
Gas/LPG models
A+B
D-6 Drive hub oil
Perform every 1500 hours:
A+B+C
D-7 Engine maintenance -
Kubota diesel models
A+B+C+D
Comments
GS-2669 RT • GS-3369 RT • GS-4069 RT
Y N R Checklist E
E-1 Test or replace
hydraulic oil
E-2 Engine maintenance -
Perkins models
E-3 Engine maintenance -
Gasoline/LPG models
E-4 Engine maintenance -
Kubota diesel models
Perform every 3000 hours:
E-5 Engine maintenance -
Perkins models
E-6 Engine maintenance -
Kubota diesel models
Y N R
November 2014
Y N R
Part No. 229753