Replace The Drive Hub Oil; Perform Engine Maintenance - Kubota Models - Genie GS-2669 RT Service Manual

November 2014
A-11

Replace the Drive Hub Oil

Note: Manufacturer drive hub specifications require
that this one-time procedure be performed after the
first 150 hours.
Replacing the drive hub oil is essential for good
machine performance and service life. Failure to
replace the drive hub oil after the first 150 hours of
use may cause the machine to perform poorly and
continued use may cause component damage.
1 Select the drive hub to be serviced. Drive the
machine until one of the two plugs is at the
lowest point.
2 Remove both plugs and drain the oil into a
suitable container.
3 Drive the machine until one of the two plugs is
at the highest point.
a drive hub plugs
4 Fill the hub until the oil level is even with the
bottom of the lowest plug hole. Refer to Section
2, Specifications.
5 Install the plugs into the drive hub.
6 Repeat this procedure for the other drive hub.
Part No. 229753
a
GS-2669 RT • GS-3369 RT • GS-4069 RT
Section 3 • Scheduled Maintenance Procedures
CHECKLIST A PROCEDURES
A-12
Perform Engine Maintenance -
Kubota Models
Engine specifications require that this procedure be
performed every 200 hours.
• Change engine oil
• Replace oil filter
• Inspect radiator hoses and clamps
• Inspect air intake hose (Kubota D1105)
Required maintenance procedures and additional
engine information is available in the
Kubota D1105 Operator's Manual
(Kubota part number 16622-89166) OR the
Kubota WG972 Operator's Manual
(Kubota part number EG801-8916-2).
Kubota D1105 Operator's Manual
Genie part number
Kubota WG972 Operator's Manual
Genie part number
131379
234803
3 - 13