Perform 30 Day Service; Replace The Drive Hub Oil - Genie S-40 Service Manual

Section 3 • Scheduled Maintenance Procedures
CHECKLIST A PROCEDURES
A-10

Perform 30 Day Service

The 30 day maintenance procedure is a one time
sequence of procedures to be performed after the
first 30 days or 40 hours of usage, whichever
comes first. After this interval, refer to the
maintenance checklist for continued scheduled
maintenance.
1 Perform the following maintenance procedures:
• A-15 Grease the Turntable Rotation Bearing
and Rotate Gear
• B-6 Inspect the Tires, Wheels and
Lug Nut Torque
• D-2 Check the Turnable Rotation Bearing
Bolts
• D-4

Replace the Drive Hub Oil

• D-6 Replace the Hydraulic Filters
3 - 12
A-11
Replace the Drive Hub Oil
Manufacturer drive hub specifications require that
this one-time procedure be performed after the first
50 hours.
Replacing the drive hub oil is essential for good
machine performance and service life. Failure to
replace the drive hub oil after the first 150 hours of
use may cause the machine to perform poorly and
continued use may cause component damage.
1 Select the drive hub to be serviced. Drive the
2 Remove both plugs and drain the oil into a
3 Drive the machine until both plugs are
4 Fill the hub until the oil level is even with the
5 Install the plugs into the drive hub.
6 Repeat this procedure for the other drive hub.
S-40 • S-45 • S-40 TRAX • S-45 TRAX
machine until one of the two plugs is at the
lowest point.
suitable container.
horizontal.
bottom of the plug hole. Refer to Section 2,
Specifications.
October 2014
Part No. 826364