Replace The Drive Hub Oil - Genie Z80/60 Service Manual

Section 3 • Scheduled Maintenance Procedures
CHECKLIST A PROCEDURES
5 Loosen the drain plug located at the bottom of
the filter. Allow the water to drain into a suitable
container until fuel starts to come out.
Immediately tighten the drain plug.
Note: Do not completely drain the filter.
a fuel filter/water separator
b drain valve
6 Clean up any fuel that may have spilled.
7 Start the engine from the ground controls and
check the fuel filter/water separator for leaks.
Explosion and fire hazard. If a fuel
leak is discovered, keep any
additional personnel from entering
the area and do not operate the
machine. Repair the leak
immediately.
8 Swing the engine back to its original position
and install the engine pivot plate retaining
fastener.
3 - 16
A-12

Replace the Drive Hub Oil

Manufacturer drive hub specifications require that
this one-time procedure be performed after the
first 150 hours.
Replacing the drive hub oil is essential for good
machine performance and service life. Failure to
replace the drive hub oil after the first 150 hours of
a
use may cause the machine to perform poorly and
continued use may cause component damage.
b
Drive Hubs:
1 Select the drive hub to be serviced. Drive the
machine until one of the two plugs is at the
lowest point.
2 Remove both plugs and drain the oil into a
suitable container.
3 Drive the machine until one plug is at the top
and the other is at 90 degrees.
models with pipe plugs
Z-80/60
June 2011
REV E
a
models with o-ring plugs
Part No. 88619