Genie GS-2669 RT Service Manual page 90

Section 4 • Repair Procedures
SCISSOR COMPONENTS
4 Raise the linkage assembly slightly with the
overhead lifting device just enough to take
pressure off of the slider feet.
5 Remove the retaining fasteners from the slider
feet pivot pins and set aside.
a c
b
a Slider foot assembly
b pivot pin
c retaining fasteners
6 Using a soft metal drift, remove the pivot pins
and set aside.
7 Remove the slider feet by sliding them out of the
slider channel.
8 Remove the upper and lower wear pads and
discard.
4 - 20 GS-2669 RT • GS-3369 RT • GS-4069 RT
9 Using a hard rubber mallet, secure the upper and
lower wear pads to the slider feet.
a
b
c
a upper wear pads
b slider foot
c lower wear pad
10 Install the slider feet into the slider channel and
secure them to the linkage assembly with the
pivot pins.
11 Securely tighten the pivot pin retaining
fasteners.
12 Securely install the ladder onto the machine. Do
not over tighten the fasteners.
November 2014
Part No. 229753