Platform Components; Platform - Genie GS-2669 RT Service Manual

November 2014
2-1

Platform

How to Remove the Platform
Bodily injury hazard. This
procedure requires specific repair
skills, lifting equipment and a
suitable workshop. Attempting this
procedure without these skills and
tools could result in death or
serious injury and significant
component damage. Dealer
service is required.
Note: This procedure will require an overhead lifting
device capable of supporting 1000 lbs / 454 kg.
1 Remove the zip tie that secures the power to
platform wiring to the bottom of the platform.
Component damage hazard. Be
sure not to cut the power to
platform wiring.
2 Remove the clamp that secures the platform
controls cable to the platform.
3 Disconnect the platform controls cable from the
connector located under the platform.
4 Remove the platform control box from the
platform and lay it off to the side.
Component damage hazard. The
platform controls wiring can be
damaged if it is kinked or pinched.
Part No. 229753

Platform Components

GS-2669 RT • GS-3369 RT • GS-4069 RT
Section 4 • Repair Procedures
5 Remove the cover to the AC power to platform
outlet. Tag and disconnect the wiring from the
outlet.
Electrocution/burn hazard. Contact
with electrically charged circuits
could result in death or serious
injury. Remove all rings, watches
and other jewelry.
Note: If your machine is equipped with an air line to
platform option, the air line must be disconnected
from the platform before removal.
6 Attach a sling chain from the overhead lifting
device to the four lifting points on the platform.
4 Places
7 Remove the two carriage bolts that secure the
platform to the platform pivot at the steer end of
the machine.
4 - 3