Replace The Drive Hub Oil - Genie S-105 Service Manual

Section 3 • Scheduled Maintenance Procedures
CHECKLIST A PROCEDURES
2 Thoroughly pump grease into each grease
fitting. When grease is pumped into each fitting,
a hose directs this lubrication to the top or
bottom wear pad.
3 Cycle the extending axles in and out.
Genie recommends that the extending axles be
cycled in and out at least once a week.
3 - 14
A-12

Replace the Drive Hub Oil

Genie specifications require that this one-time
procedure be performed after the first 150 hours of
operation.
Replacing the drive hub oil is essential for good
machine performance and service life. Failure to
replace the drive hub oil after the first 150 hours
may cause the machine to perform poorly and
continued use may cause component damage.
Drive Hubs:
1 Select the drive hub to be serviced. Drive the
machine until one of the two plugs is at the
lowest point.
2 Remove both plugs and drain the oil into a
suitable container. Refer to capacity
specifications
3 Drive the machine to rotate the hub until the
plugs are located one at the side and the other
at the other side.
4 Fill the hub with oil from either plug hole until the
oil level is even with the bottom of both plug
holes. Install the plugs.
5 Repeat steps 1 through 4 for all the other drive
hubs.
S-100 • S-105 • S-120 • S-125
a drive hub plugs
Part No. 102916
June 2011
REV B
a