Genie GS-2669 RT Service Manual page 115

November 2014
11 Adjust the "Y" axis (side-to-side) to 2.5V DC.
Tap the top of the level sensor lightly with
fingers after each turn of an adjusting nut.
Tip-over hazard. Do not adjust the
potentiometers on the bottom of
the level sensor or calibrate the
level sensor other than specified in
this procedure. Failure to calibrate
the tilt level sensor as instructed
will cause the machine to tip over
resulting in death or serious injury.
Note: Be sure there are threads showing through
the top of each adjusting nut.
d
X
c
Y
a chassis
b level sensor
c "Y" indicator
d "X" indicator
12 Disconnect the positive lead.
Part No. 229753
a
b
GS-2669 RT • GS-3369 RT • GS-4069 RT
Section 4 • Repair Procedures
Adjust the front-to-back axis:
13 Without disconnecting the wire harness from the
level sensor, connect the positive lead of the
multimeter to the blue wire at the level sensor.
14 Adjust the "X" axis (front-to-back) to 2.43V DC.
Tap the top of the level sensor lightly with
fingers after each turn of an adjusting nut.
Tip-over hazard. Do not adjust the
potentiometers on the bottom of
the level sensor or calibrate the
level sensor other than specified in
this procedure. Failure to calibrate
the tilt level sensor as instructed
will cause the machine to tip over
resulting in death or serious injury.
Note: Be sure there are threads showing through
the top of each adjusting nut.
15 Disconnect the positive and negative leads.
16 Apply Sentry Seal to the adjusting nuts.
17 Push in the red Emergency Stop button to the
off position at the platform controls.
18 Press and hold the auto level button and press
and hold the left front outrigger button. Pull out
the red Emergency Stop button to the on
position at the platform controls. Continue to
hold the auto level button and left front outrigger
button for approximately 3 seconds or until a
beep is heard. Release the buttons.
19 Push in the red Emergency Stop button to the
off position at the platform controls.
GROUND CONTROLS
4 - 45