Oscillate Hoses - Genie GS-2669 RT Service Manual

November 2014
11-5

Oscillate Hoses

Test the Oscillate Axle Hose
Routing
Note: Perform this procedure if the oscillate hoses
have been removed or replaced.
1 Open the ground controls compartment and
locate the function manifold. Refer to illustration
1, item A.
illustration 1
Part No. 229753
A
GS-2669 RT • GS-3369 RT • GS-4069 RT
Section 4 • Repair Procedures
STEER AXLE COMPONENTS
2 Tag and disconnect the connector with the red
wire from the oscillate left coil (item A) and the
connector with the white wire from the oscillate
right coil (item B) and set aside. Refer to
illustration 2.
A B
illustration 2
3 Tag and disconnect the connector with the blue
wire from the steer right coil (item C). Connect it
to the oscillate right coil (item B). Refer to
illustration 2.
4 Tag and disconnect the connector with the blue/
black wire from the steer left coil (item D).
Connect it to the oscillate left coil (item A).
Refer to illustration 2.
5 Turn the key switch to platform controls and pull
out the red Emergency stop buttons to the on
position at both the ground and platform
controls. Start the engine.
Note: During this procedure a fault code 64 will
appear on the ground controls display.
C D
4 - 73