Genie GS-2669 RT Service Manual page 87

November 2014
24 Using an overhead lifting device attach a 4 hook
sling chain to the ends of the number 3 inner
arm (index #9). Make the chains tight but do not
apply lifting pressure.
Crushing hazard. The linkage
assembly could become
unbalanced and fall if not properly
supported when removed from the
machine.
25 Remove the retaining fasteners from the number
3 pivot pins (index #10 and #25).
Note: Do not remove the external snap ring.
26 Using a soft metal drift, remove the pivot pins
and set aside.
27 Carefully lift the linkage assembly off of the
machine and place it on a structure capable of
supporting it.
Part No. 229753 GS-2669 RT • GS-3369 RT • GS-4069 RT
Section 4 • Repair Procedures
28 Using an overhead lifting device attach a 4 hook
sling chain to the ends of the number 2 inner
arm (index #26). Make the chains tight but do
not apply lifting pressure.
Crushing hazard. The linkage
assembly could become
unbalanced and fall if not properly
supported when removed from the
machine.
29 Remove the retaining fasteners from the number
2 pivot pins (index #12 and #28).
Note: Do not remove the external snap ring.
30 Using a soft metal drift, remove the pivot pins
and set aside.
31 Carefully lift the linkage assembly off of the
machine and place it on a structure capable of
supporting it.
SCISSOR COMPONENTS
4 - 17