Scissor Assembly, Gs-2669 Rt - Genie GS-2669 RT Service Manual

November 2014
3-1

Scissor Assembly, GS-2669 RT

How to Disassemble the
Scissor Assembly
Bodily injury hazard. This
procedure requires specific repair
skills, lifting equipment and a
suitable workshop. Attempting this
procedure without these skills and
tools could result in death or
serious injury and significant
component damage. Dealer
service is required.
Note: When removing a hose assembly or fitting,
the O-ring on the fitting and/or hose must be
replaced and then torqued to specification during
installation. Refer to Section 2, Hydraulic Hose and
Fitting Torque Specifications .
Note: This procedure will require an overhead lifting
device and sling chains capable of supporting
1000 lbs / 454 kgs.
1 Remove the platform. See 2-1, How to Remove
the Platform.
2 Remove the retaining fasteners that attach the
ladder to the drive chassis. Remove the ladder
and set aside.
3 Remove the cables from the linkage assembly.
Component damage hazard.
Cables can be damaged if they are
kinked or pinched.
Part No. 229753 GS-2669 RT • GS-3369 RT • GS-4069 RT
Section 4 • Repair Procedures
4 Using a suitable supporting device, attach a
strap to the rod end of the lift cylinder. Do not
apply pressure.
5 Remove the lift cylinder rod end pivot pin (index
#3) retaining fasteners.
6 Using a soft metal drift, remove the pivot pin.
7 Lower the lift cylinder and remove the strap.
8 Using an overhead lifting device attach a 4 hook
sling chain to the ends of the number 3 inner
arm (index #10). Make the chains tight but do
not apply lifting pressure.
Crushing hazard. The linkage
assembly could become
unbalanced and fall if not properly
supported when removed from the
machine.
9 Remove the retaining fasteners from the number
3 pivot pins (index #4 and #13).
Note: Do not remove the external snap ring.
SCISSOR COMPONENTS
4 - 7