Genie GS-2669 RT Service Manual page 79

November 2014
20 Remove the two carriage bolts that secure the
inner arm and chassis pivot to the steer end of
the drive chassis.
21 Move the linkage towards the non-steer end of
the machine until the slider feet are clear of the
slider channel.
22 Carefully lift the linkage assembly off of the
machine and place it on a structure capable of
supporting it.
Separate the link sets:
1 Using an overhead lifting device attach a 4 hook
sling chain to the ends of the inner arm (index
#8, #11 or #14). Make the chains tight but do
not apply lifting pressure.
Crushing hazard. The linkage
assembly could become
unbalanced and fall if not properly
supported when removed from the
machine.
2 Remove the retaining fasteners from the center
pivot pins (index #5, #7 or #12).
Note: Do not remove the external snap ring.
3 Using a soft metal drift, remove the center pivot
pins and set aside.
4 Carefully lift and separate the linkage assembly
apart and place it on a structure capable of
supporting it.
Part No. 229753 GS-2669 RT • GS-3369 RT • GS-4069 RT
Section 4 • Repair Procedures
SCISSOR COMPONENTS
4 - 9