Platform Overload Recovery Message - Genie GS-2669 RT Service Manual

November 2014
14-2
Platform Overload Recovery
Message (software version B3
and later)
If the ground controls LCD screen displays Ovrld
Recovery, the emergency lowering system has
been used while the platform was overloaded.
Note: This message shall be cleared by a person
trained and qualified on the troubleshooting and
repair of this machine.
Note: Use the following illustration to identify the
description of each control button used in this
procedure.
a
a LCD screen
b up button
c function enable button
d down button
1 Turn the key switch to the ground controls
position and pull out the red Emergency stop
button to the on position at the platform
controls.
Part No. 229753
b
c
d
GS-2669 RT • GS-3369 RT • GS-4069 RT
Section 4 • Repair Procedures
PLATFORM OVERLOAD COMPONENTS
2 Press and hold both the up and down buttons.
Pull out the red Emergency Stop button to the
on position at the ground controls.
Result: is showing in the LCD
TUNE SPEEDS
screen.
3 Use the down button to scroll to
4 Press the function enable button.
Result:
DESCENT DELAY
screen.
5 Use the down button to scroll to
6 Press and hold the function enable button for 5
seconds.
Result: A screen will appear asking for the
overload recovery passcode.
7 Press the buttons in the following sequence:
(down) (down) (up) (enable).
Result: The LCD screen displays
returns to the
OVERLOAD
8 Use the down button to scroll to
.
MENU
9 Press the function enable button.
Result:
SELECT OPTIONS
screen.
10 Push in the red Emergency Stop button to the
off position at the ground controls.
SELECT OPTIONS
is showing in the LCD
.
OVERLOAD
and
CLEARED
screen.
RETURN TO MAIN
is showing in the LCD
4 - 81
.