Procedure For Using Tag Data Links - Omron CJ1W-EIP21 Operation Manuals

1-5-2

Procedure for Using Tag Data Links

This section gives the setup procedure up to starting tag data links. Use the Network Configurator to set
the tag data link parameters to use for tag data links.
1
Import the settings of the variables that you specified for the tags on
the Sysmac Studio to the Network Configurator.
2
Use Network Configurator to create the tag data link table.
• Create the network configuration.
• Set the tags, tag sets, and connections.
3
Connect the Network Configurator online.
4
Download the tag data link settings.
5
Start the tag data links (the links start automatically when power is
turned ON).
6
Check operation.
• Check the indicators on the EtherNet/IP Unit.
• Use the Sysmac Studio to check the communications status with the All Tag
Data Link Communications Status system-defined variable.
• Use the monitor function of the Network Configurator to confirm that the tag
data links are in normal operation.
Additional Information
Status information on the target nodes for tag data links is provided in device variables for the
CJ-series Unit. You can also store it in user-defined variables.
User-defined Variables to Which the Status Areas Are Assigned on page 3-5.
CJ-series EtherNet/IP Units Operation Manual for NJ-series CPU Unit (W495)
↓
↓
↓
↓
↓
1 Introduction
7-2-4 Creating Tags and Tag
Sets
Section 7 Tag Data Link
Functions
7-2-8 Connecting the Net-
work Configurator to the Net-
work
7-2-9 Downloading Tag Data
Link Parameters
7-2-12 Starting and Stopping
Tag Data Links
1-3-2 Part Names and Func-
tions
Section 13 Troubleshooting
1-23
1