5 Sysmac Studio Settings for the EtherNet/IP Unit
Trap 1
*1
Setting
Specifying method
*2
IP address
Host name
Community name
Version
Trap 2
*1
Setting
Specifying method
*2
IP address
Host name
Community name
Version
*1 These settings are required if the SNMP trap is set is enabled.
*2 Due to Ethernet restrictions, you cannot specify the IP addresses that are described below.
• IP addresses that start with 127, 0, or 255 (decimal)
• Class-D IP addresses (224.0.0.0 to 239.255.255.255)
• Class-E IP addresses (240.0.0.0 to 255.255.255.255)
5-12
Description
Set the specifying method for the SNMP manager destination for SNMP
traps.
• IP address
• Host name
Set the IP address of the SNMP manager.
(Set this setting if the specifying method in the trap 1 settings is set to the IP
address Option.)
Set the host name of the SNMP manager.
(Set this setting if the specifying method in the trap 1 settings is set to the
Host name Option.)
(You can use up to 200 single-byte alphanumeric characters, dots, and
hyphens with up to 63 single-byte alphanumeric characters between dots.)
Set the community name.
(You can use up to 200 alphanumeric characters.)
Set the version of the SNMP manager.
• SNMPv1
• SNMPv2C
Description
Set the specifying method for the SNMP manager destination for SNMP
traps.
• IP address
• Host name
Set the IP address of the SNMP manager.
(Set this setting if the specifying method in the trap 2 settings is set to the IP
address Option.)
Set the host name of the SNMP manager.
(Set this setting if the specifying method in the trap 2 settings is set to the
Host name Option.)
(You can use up to 200 single-byte alphanumeric characters, dots, and
hyphens with up to 63 single-byte alphanumeric characters between dots.)
Set the community name.
(You can use up to 200 alphanumeric characters.)
Set the version of the SNMP manager.
• SNMPv1
• SNMPv2C
CJ-series EtherNet/IP Units Operation Manual for NJ-series CPU Unit (W495)
Default
IP address
0.0.0.0
None
public
SNMPv2C
Default
IP address
0.0.0.0
None
public
SNMPv2C