Omron CJ1W-EIP21 Operation Manuals page 341

Connection status
General Additional
Status
(hex)
01 011B
01 0203
01 0204
01 0205
01 0302
01 0311
01 0312
01 0315
01 0316
CJ-series EtherNet/IP Units Operation Manual for NJ-series CPU Unit (W495)
Source of error
Status
(hex)
Error code returned from tar-
get:
The RPI was set to a value
that is below the specifica-
tions.
Error code returned from tar-
get:
The connection timed out.
Error code returned from tar-
get:
The connection-opening pro-
cess timed out.
Error code returned from tar-
get:
There was a parameter error
in the frame used to open the
connection.
Error occurred at originator or
error code returned from tar-
get:
The tag data link's allowable
bandwidth (pps) was
exceeded.
Error code returned from tar-
get:
There was a parameter error
in the frame used to open the
connection.
Error code returned from tar-
get:
There was a parameter error
in the frame used to open the
connection.
Error code returned from tar-
get:
There was a parameter error
in the frame used to open the
connection.
Error code returned from tar-
get:
There was a parameter error
in the frame used to close the
connection.
13 Troubleshooting
Handling
Configuration Configuration
1 2
This error does Depends on
not occur. the target's
specifications.
(Contact the
target device's
manufacturer.)
Tag data link communications from the target timed
out. Check the power supply and cable wiring of the
devices in the communications path, including the
target and switches. If performance has dropped
due to heavy load, change the performance set-
tings. For example, increase the timeout time or RPI
setting.
There was no response from the target. Check the
power supply and cable wiring of the devices in the
communications path, including the target and
switches.
This error does Depends on
not occur. the target's
specifications.
(Contact the
target device's
manufacturer.)
Check the origi- Check the tar-
nator and tar- get's connec-
get connection tion settings
settings (num- (number of con-
ber of connec- nections and
tions and RPI). RPI).
This error does Depends on
not occur. the target's
specifications.
(Contact the
target device's
manufacturer.)
This error does Depends on
not occur. the target's
specifications.
(Contact the
target device's
manufacturer.)
This error does Depends on
not occur. the target's
specifications.
(Contact the
target device's
manufacturer.)
This error does Depends on
not occur. the target's
specifications.
(Contact the
target device's
manufacturer.)
Configuration
2
Set the origina-
tor's RPI setting
to 0.5 ms or
greater.
Depends on
the originator's
specifications.
(Contact the
13
originator
device's manu-
facturer.)
Check the origi-
nator and tar-
get connection
settings (num-
ber of connec-
tions and RPI).
Depends on
the originator's
specifications.
(Contact the
originator
device's manu-
facturer.)
Depends on
the originator's
specifications.
(Contact the
originator
device's manu-
facturer.)
Depends on
the originator's
specifications.
(Contact the
originator
device's manu-
facturer.)
Depends on
the originator's
specifications.
(Contact the
originator
device's manu-
facturer.)
13-23